Zhongke Tianpu solar bracket installation

Why should you install a solar panel bracket?

The purpose of installing the bracket is to better fix the solar panel. If there is a more convenient and feasible method to fix the solar panel. PVMars will definitely recommend it to you, and effective solutions are based on solar panels’ characteristics and your on-site installation environment.

Are solar stack roof mounting systems ul 2703 listed?

Solar Stack Roof mounting systems are UL 2703 listed. Standard for safety UL/ANSI 2703, Mounting Systems, Mounting devices, Clamping/Retention Devices and Ground lugs for use with PV modules. Solar Stack systems have been evaluated for module-to-system bonding and mechanical load to the requirements of UL/ANSI 2703.

How do I install a solar stack module?

Insert the middle clamps and tighten them. Insert the end clamps laterally in the pedestal. The end clamps are attached and then tightened at the height of the module frame. Modules should be installed to the Solar Stack pedestals with the manufacturer approved middle/end clamps.

How do I connect a solar stack module to a pedestal?

Modules should be bonded to the Solar Stack pedestals with the manufacturer approved middle/end clamps. Grounding hardware (as a part of the module clamps) forms secure electrical bonds with both the module and the pedestal, resulting in many parallel grounding paths throughout the system.

How do solar panels attach to a roof?

The most common roof mounted structure of all. Consists of attaching a set of rails to the rooftop. Each solar panel is then attached to the rails through a set of clamps. The rails are secured to the rooftop by screws and bolts. This type of installation directly uses bolts and screws to secure each panel to the roof.

Are solar racking systems UL/ANSI 2703 compliant?

Solar Stack systems have been evaluated for module-to-system bonding and mechanical load to the requirements of UL/ANSI 2703. This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions.